Mixing
Mix bus compression in Logic Pro
Bus compression means compressing a group — drums, vocals or the whole stereo mix — so the parts move together. Logic Pro's Compressor has VCA circuit types that writers at Sound On Sound and MusicTech associate with classic console bus compressors, so you don't need a third-party plug-in.

Where to find it
Stereo Out or aux > Dynamics > Compressor
Bus compression starting points

| Control | Starting idea |
|---|---|
| Circuit type | A VCA type |
| Ratio | Low for the full mix; MusicRadar used 4:1 on a house beat |
| Threshold | Just enough for light gain reduction on peaks |
| Attack | Slower to keep transients |
| Release | Moving with the groove |
| Mix | Below 100% for a parallel blend |
These are starting points from the articles cited, not rules — every mix differs.
Step by step
-
1
Decide when to add it
MusicRadar describes two approaches: add it once the mix is balanced, or mix "into" it from early on while watching gain reduction.
-
2
Insert Compressor
Put Compressor on the Stereo Out, or on a drum or vocal aux, and choose a VCA circuit type.
-
3
Set a gentle ratio
Start with a low ratio and lower the threshold until the meter shows a little gain reduction on the loudest parts.
-
4
Set attack and release
A slower attack lets transients through; set release so the needle moves with the groove. MusicRadar used 4:1 with a 0.1 s release on a four-to-the-floor house track.
-
5
Blend and compare
Use the Mix control for parallel blending, and bypass at matched loudness to check it helps.
Common mistakes
- Using bus compression to fix a mix that isn't balanced yet.
- Changing EQ before the compressor and forgetting it changes how it reacts.
- Judging it louder-is-better instead of at matched level.
Related compression guides
Learn every circuit type in Compressor, try parallel compression, and finish with the mastering chain.
Sources
- Sound On Sound — Logic's Master Blasters, part 2 (bus compression)
- MusicTech — Understanding compressor circuit types in Logic
- MusicRadar — How to compress your mix bus
- Production Expert — 2-bus compression with Logic Pro's Compressor
- Sound On Sound — Logic compressor circuit types and glue
Checked November 2026. Logic ProFiles is independent of Apple; menu names can differ slightly between Logic Pro versions.
Frequently asked questions
Which Compressor circuit type is best for the mix bus?
+
Writers often suggest a VCA type for "glue"; Sound On Sound compared the VCA type to classic console bus compressors. Try others and trust your ears.
Does kick and bass drive the bus compressor?
+
MusicRadar notes low-frequency content such as kick and bass usually drives a mix bus compressor.
Related
- Logic Pro Compressor and its circuit typesLogic Pro's Compressor has seven circuit types — Platinum Digital, Studio and Classic VCA, Studio FET and Vintage VCA, FET and Opto. Pick one and set it up.
- Parallel compression in Logic Pro — two easy methodsDo parallel compression in Logic Pro two ways: with the Compressor's Mix knob on the track, or by sending drums to an aux with a heavily compressed Compressor.
- A mastering chain in Logic Pro with only stock plug-insMaster in Logic Pro by hand with stock plug-ins: EQ, compression, Adaptive Limiter with the right Out Ceiling and True Peak Detection, then the Loudness Meter.
- Track Stacks in Logic Pro — folder vs summing stacksGroup tracks in Logic Pro with Track Stacks: when to use a Folder Stack or a Summing Stack, how to create, nest and open them, and why summing stacks are buses.
- Mix and master in Logic ProMix and master songs in Logic Pro with stock tools: vocal tuning, EQ, compression, sends, automation, Mastering Assistant, LUFS targets and Dolby Atmos.